TanklessCalc

Disclaimer

Last updated: 2026-11-17

Everything on TanklessCalc is an estimate produced from the values you enter. It is offered in good faith, using published constants and standard formulas, and it is still only arithmetic.

Not professional advice

Sizing results are planning estimates from published fixture flow rates and physical constants, not an assessment of a specific building. A calculation cannot see your site, your materials, your equipment or your circumstances. Where a decision carries a cost or a risk, take advice from someone qualified who can look at the actual situation.

Verify before you rely on it

  • Check the result against your own measurements.
  • Confirm anything regulated with the body that publishes the rule.
  • Read the coverage figure on your own product rather than assuming the conventional one.
  • Buy or commit in stages where a mistake would be expensive.

Data sources

Where this site publishes data rather than arithmetic, the source is named on the page that shows it. The main sources are:

  • Federal maximum flow rates for showerheads (2.5 GPM) and faucets (2.2 GPM)
  • Rinnai RU-series (Sensei) specification sheet and Rinnai RV53E manual
  • Rheem RTEX specification sheet TKE-101 and Stiebel Eltron Tempra engineering specification sheet
  • National Electrical Code 240.6(A) breaker sizes and Table 310.16 copper ampacity, as published in Cerrowire’s ampacity chart

Those sources carry their own accuracy limits, which are described on the methodology page. Where a figure depends on an assumption, the page that shows it says so.

No liability

See the terms of use. In short: we are not liable for losses arising from reliance on an estimate, and you should not rely on one where the consequence of being wrong is serious.